Studio Freestanding Installation User Instructions

24
4. Fitting of Internal Components
Once the inner box has been installed the internal
components can be fitted.
4.1 The firebricks must be fitted before the baffle components.
Firebricks
4.2 The Firebricks and Lower Baffle bricks are supplied in a box
for safe transportation. It is advisable to carefully remove all
of the bricks from the container in order to correctly identify
the various types.
4.3 The side bricks have part of the Log bar supports attached.
These must be fitted and removed at the same time as the
bricks.
4.4 Install in the following order, see Diagram 9.
Take care when handling and do not force into position.
3
3
2
1
9
Picture for illustration only -
brick shape may vary depending on model
4.5 To do this:
All Models
— Place the base bricks in the firebox (1).
Fit the left and right hand base bricks, then the middle.
— Place the back bricks in position on top of the base
bricks (2).
— Fit the side bricks (3) with the Log Guard Supports in
place. The Log Bar Support holes can be used as a finger
hold - follow the method for the relevant model.
Studio 500 & 1
Tilt the brick at an angle and feed the top edge up and into
the gap at the top of the firebox.
Straighten the brick in this position and lower into the
gap between the side of the inner box and the base
brick ensuring the Log Bar Support remains in place, see
Diagram 10 and 11.
10
Log Bar
Support
Bracket
11
Rear of Brick
Log Bar
Support Hole
Log Bar
Support
Bracket
Studio 2 & 3
Tilt the brick at an angle and feed the lower edge down into
the gap between the base brick and the side of the inner
box.
Straighten the brick in this position and drop into place
ensuring the Log Bar Support remains in place, see
Diagram 11 and 12.
12
Log Bar
Support
Bracket
4.6 Repeat for the other side.
Installation Instructions