Instructions

6
Rev08032022
5. Update MODE COM software
a. Press the arrow next to "Update Software" on the settings screen. See figure 16.
b. A window will pop up asking if you are sure you want to update software, press "YES".
c. The screen will now say "Waiting for Connection or USB". Plug in the USB that has been loaded
with the updated software to the MODE COM USB port that you located in the previous steps.
d. Once the USB is recognized, the system will prompt you to “Select File to Load”. If needed, use
the up and down arrows on the left side of the screen to index to the correct updated software
file as displayed in the middle of the screen. This should be the file that you copied onto your
USB. Once found, press the green right arrow at the top left of the screen. See figure 17.
e. The screen will now prompt you to confirm the file to load. If the file name listed is correct, press
the right arrow on the left side of the screen to begin the update process. NOTE: Allow the
update to complete automatically. During the update, the system will restart itself
automatically which may cause the lights and other accessories to power off momentarily.
Allow the system to fully complete the update process on its own before pressing any controls
in the van.
Figure 16
Press to start
software update
Figure 17
Check filename
matches updated
software version
Once filename is correct
press right arrow
Use up and down arrow to
index to the software file