Instructions

4
Rev08032022
e. To remove the MODE COM panel, use your hands to wiggle the panel loose at the top and sides
and slide out from the wall and around the screens. See figures 9a and 9b. NOTE: Be very careful
to not damage the ceiling, wall, or cabinet finishes. Do not pull too hard on the panel. Also do
not pull the panel far away from the wall as the Volta push button will still be connected.
f. Once the panel has been worked loose from
the wall and screens, gently allow it to hang
down by the pushbutton harness as shown in
figure 10.
g. Reach your hand behind the MODE COM
screen's bottom edge to retrieve the USB port
and position below the screen as shown in
figure 11. Proceed to step 5.
Figure 9a
Wiggle the panel loose at
the top and sides to feed
around the screens
Figure 9b
Pull panel out from
the wall and around
the screens
Figure 10
Gently hang
the panel
down by the
pushbutton
harness
Retrieve USB port from
behind the MODE COM
screen and position below
the screen
Figure 11