MSDS

Page 2: Storm System™ 100% Acrylic Latex Stain for Siding, Matte #412XX Series
FIRE EXTINGUISHING MATERIALS: Use extinguishing media appropriate for surrounding fire
Water Spray: OK Carbon Dioxide: OK
Foam: OK Dry Chemical: OK
Halon: OK Other: Any “ABC” Class
6. Accidental release measures:
Personal precautions: Do not get in eyes. Do not take internally. Avoid skin contact. Prevent prolonged or repeated
breathing of vapor or spray mists. Keep unnecessary people away. Floor may be slippery, use care to avoid falling.
Dike and contain material with inert material (e.g. earth, sand). Transfer liquid and contaminated diking material to
separate containers for disposal. Environmental precautions: Keep spills and cleaning run-offs out of municipal sewers
and open bodies of water. Comply with local, national and state regulations.
7. Handling and Storage:
Keep closure tight and containers upright to prevent leakage. Precautionary labeling: KEEP FROM FREEZING".
Product is non-combustible.
8. Exposure Controls and Personal Protection:
General protection and hygienic measures: Avoid contact with skin. Do not get in eyes. Do not take internally. Avoid
breathing vapors or spray mists. Use in well-ventilated areas. Hand/skin protection: Wear neoprene or rubber gloves to
prevent skin contact. Wash hands before eating, smoking or using the wash room. Food or beverages should not be
consumed anywhere this product is handled or stored. Respiratory protection: None required if good ventilation is
maintained. Wear respirator suitable for concentrations and of contaminants encountered. Use approved
chemical/mechanical filters designed to remove particulates in open and restricted ventilation areas. Use approved
airline type respirators or hoods in confined areas. Eye/face protection: Use approved safety eyewear including side
shields, chemical goggles and face shields.
9. Physical and Chemical Properties:
Forms: Viscous liquid, slight ammoniacal odor
Density: Varies with product color
Solubility in water: Complete colloidal dispersion
10. Stability and Reactivity:
Stability: Hazardous polymerization will not occur. Stable. Hazardous reactions: Avoid contact with strong oxidizing
agents (e.g. nitric acid, permanganates), etc.
11. Toxicological Information:
This product may contain more that 0.1% crystalline silica (CAS #14808-60-7) which has been classified by IARC as a
Class I carcinogen. Normal application procedures pose no hazard since the silica is wet and encapsulated, but grinding
or sanding dried films may yield respirable silica dusts. Control exposures to less than 0.1 mg per cubic meter of air
using approved dust filter respirators. Skin contact: Prolonged or repeated contact with product may cause slight skin
irritation. Impervious gloves should be worn if prolonged skin contact is likely.
12. Ecological Information:
Well-diluted product would have no environmental consequences. Less than 5% ethylene glycol present in this product
yields the following environmental fate considerations: Ethylene glycol is 100% volatile. Once volatilized, it will react in
the atmosphere with hydroxyl radicals with a half-life on about 1 day. For accidental spills, note that ethylene glycol in
typical river water at 20°C was found to completely degrade in 3 days. At temperatures of 8°C, degradation occurred in 7
days. Toxicity to fish: LD50 Carrasisus auratus (goldfish) greater than 5,000 gl/L/24 hour. Modified ASTM D 1345.
Algea:(Chlorella pyrenoidosa) 180,000 mg/L toxic.