Use and Care Manual
Table Of Contents
- Slide 1: ASSEMBLY & INSTALLATION INSTRUCTIONS
- Slide 2: Before getting started, let’s make sure this Storm Shell will work for you!
- Slide 3: Before getting started, let’s make sure this Storm Shell will work for you!
- Slide 4
- Slide 5
- Slide 6
- Slide 7
- Slide 8
- Slide 9
- Slide 10
- Slide 11
- Slide 12
- Slide 13
- Slide 14
- Slide 15
- Slide 16
- Slide 17
- Slide 18
- Slide 19
- Slide 20
- Slide 21
- Slide 22
- Slide 23
- Slide 24
- Slide 25
- Slide 26
- Slide 27
- Slide 28
- Slide 29
- Slide 30
- Slide 31
- Slide 32
- Slide 33
- Slide 34
- Slide 35
- Slide 36
- Slide 37
22
2A-10 Mount Storm Shell Back
• Drill through two lower holes with 5/32” wood drill bit, 1.5” deep.
• Drill through four TV Bracket holes with 1/4” wood drill bit. If
installation is over drywall, drill 2.5” deep. If installation is over
outdoor siding, drill 4” deep.
• Ensure all drill holes are on studs.
2.5” for G6
bolt, 4” for
J6 bolt
1/4”
1.5”
5/32”
• Hang Storm Shell Back on the
two E6 screws previously
mounted into the wall.
2A-11 Mount Storm Shell Back