Installation Guide
Table Of Contents
- Slide 1: ASSEMBLY & INSTALLATION INSTRUCTIONS
- Slide 2: Before getting started, let’s make sure this Storm Shell will work for you!
- Slide 3: Before getting started, let’s make sure this Storm Shell will work for you!
- Slide 4
- Slide 5
- Slide 6
- Slide 7
- Slide 8
- Slide 9
- Slide 10
- Slide 11
- Slide 12
- Slide 13
- Slide 14
- Slide 15
- Slide 16
- Slide 17
- Slide 18
- Slide 19
- Slide 20
- Slide 21
- Slide 22
- Slide 23
- Slide 24
- Slide 25
- Slide 26
- Slide 27
- Slide 28
- Slide 29
- Slide 30
- Slide 31
- Slide 32
- Slide 33
- Slide 34
2A-2 Locate and mark four studs (16” center) to mount the Storm Shell Back
15
2A-3 Mount Storm Shell Back
Note!
If you desire a different mounting position than shown (left-to-
right), an Adapter Mounting Plate is required (not included). See
www.StormShellTV.com/accessories
• Place Storm Shell Back at desired installation location
• Mark in top left “key-hole” (ensure the mark is over a stud)
Mark four
stud locations