Installation Guide
Table Of Contents
- Slide 1: ASSEMBLY & INSTALLATION INSTRUCTIONS
- Slide 2: Before getting started, let’s make sure this Storm Shell will work for you!
- Slide 3: Before getting started, let’s make sure this Storm Shell will work for you!
- Slide 4
- Slide 5
- Slide 6
- Slide 7
- Slide 8
- Slide 9
- Slide 10
- Slide 11
- Slide 12
- Slide 13
- Slide 14
- Slide 15
- Slide 16
- Slide 17
- Slide 18
- Slide 19
- Slide 20
- Slide 21
- Slide 22
- Slide 23
- Slide 24
- Slide 25
- Slide 26
- Slide 27
- Slide 28
- Slide 29
- Slide 30
- Slide 31
- Slide 32
- Slide 33
- Slide 34
Determine the wall material and wall supports. Wall supports are typically
wood or metal studs, concrete, structural brick or masonry. Wall material
(cladding) is typically drywall, siding (vinyl or aluminum), stucco, brick veneer.
Step 2 – Attach Storm Shell Back to Wall
14
2A-1 Locate and Mark Wood Studs
• For wood stud installation, follow STEP 2A
• For solid concrete installation, follow STEP 2B
• For hollow wall installation (metal studs, concrete block), follow STEP 2C
CAUTION!
The Storm Shell TV Wall Mount must be secured into concrete,
structural brick or masonry, wood or metal studs. Do not mount
directly into drywall or plywood.
Step 2A – Wood Stud Installation
CAUTION!
Two people required for installation
If the wall material is
outdoor siding (vinyl or
aluminum), stucco, or brick
veneer; the wood studs may be
difficult to locate with a stud finder
due to several layers of
construction cladding. You may
need to locate the wood stud from
the inside wall and use
measurements to locate the wood
stud on the outdoor wall.
NOTE!