Use and Care Manual
example, a 32” display), you may need to adjust the location of this mounting screw. This mounting
screw will be placed in the top right keyhole of the Storm Shell Back – see Figure 5 below.
3. Lift the Storm Shell Back to the wall and position the S7 screw head (Step 2) into the top right
keyhole (Figure 5). Place a bubble level on top of the Storm Shell Back and rotate until the Storm
Shell Back is Level. Place a mark on the wall through the top left keyhole. Make sure to mark the
top left key hole at the center of the top (where the screw will rest). Remove the Storm Shell Back
from the wall and check to ensure that the mark for the top left keyhole is centered on a stud.
Repeat the procedure in Step 2 to drill and screw an S7 screw for the top left keyhole. Mount the
Storm Shell Back on the wall using the mounted screws and the top left and right keyholes. Check
that the Storm Shell Back is level using the bubble level.
Figure5
4. Place a mark through the Storm Shell Back onto the wall in the remaining five (5) mounting
locations (Figure 6). Remove the Storm Shell Back from the wall and ensure that the five (5)
remaining mounting location marks are located over a stud. For position B, use the same drill
procedure as Step 2 (1/8” drill bit 1.5 inches deep). For position A, drill a hole using a 1 4
⁄
” drill bit,
3 inches deep.
Figure6 – Storm Shell Back Mounting Locations
A
A
A
B
B
B
B
Top Right Keyhole
Top Left Keyhole