Use and Care Manual

PreparetheStormShellBack

 Remove the TV bracket from the Storm Shell Back by unscrewing the two shipping screws

(Figure 2).

 Assemble the four buckle latches (B1) onto the Storm Shell Back using the S6 screws (Figure

3). 

  

Figure2



Figure3

InstalltheStormShellBackontothewall

Two people are needed for this installation.

A) WoodStudInstallation

1. Use a high quality electronic stud finder (commercially available) to locate dead center of three

adjacent wood studs spaced 16” apart. Mark the location of each stud (Figure 4). Note: If a

different placement of the 44” Storm Shell is required to center the TV in a particular space, or if the

wall studs are built at 20” spacing, then an Adapter Mounting Plate will be required. Please consult

Item “44 Storm Shell Adapter Mounting Plate”, as shown on StormshellTV.com/Products.

Figure4

2. Determine the height location for the top of the TV mounting display. Mark this height on the

center of the mounting stud positioned furthest to the right. Drill a hole into the stud at this location

using a 18

⁄

” drill bit 1.5 inches deep. Screw one of the S7 screws into this location, leaving the

head about 18

⁄

” away from the wall. Note: if the TV display is smaller than the 44” Storm Shell (for

Screws:

S6: ST3.5X20: 12

B1: Buckle Latch