Use and Care Manual


Figure13
9. Fix the Hook Plate and Extension Bars to the back of the TV Display by connecting the proper
screw (S3/S4/S5) into the VESA holes. Select the proper washer (W1/W2/W3) to be used
with the screws. Figure 14.

Figure14
10. Lift the TV Display (with the Hook Plate firmly attached to the back) and slide the Hook Plate
in place on the Swing Arm (Figure 14). Replace the securing screws that were removed in
Step 6.
ThefollowingstepsarerequirediftheVESAholepatternisnotcenteredvertically(toptobottom)
ontheTV.
For VESA hole patterns 100 mm wide, follow steps 11 – 14. For VESA hole patterns 200 mm wide,
skip to step 15.
11. Measure the TV height and determine the center height position. Place a mark or piece of
tape at the center height position. Measure the height of the Hook Plate and place a mark
or piece of tape at the center height position of the Hook Plate. When the Hook Plate is
attached to the TV, the two center marks should match.
12. Fix the Vertical VESA Mounting Plates to the back of the TV Display by connecting the proper
screw (S3/S4/S5) into the VESA holes. Select the proper washer (W1/W2/W3) to be used
with the screws. The Vertical VESA Mounting Plates should be mounted in a position where
the Hook Plate can be attached and centered to the TV. Figure 15.
Screws:
S1- M6X10 Screw: 4pcs
S2- M8X10 Screw: 4pcs