Use and Care Manual

6. The Extension Bars (B2) on the TV Bracket can be configured to match the corresponding VESA
hole pattern. When the Extension Bars (B2) are removed from the Hook Plate, the Hook Plate
will accommodate a 100 mm x 100 mm or a 200 mm x 200 mm VESA hole pattern. Other
configurations are shown in Figure 11.

Figure11
7. Remove the Hook Plate from the Swing Arm by removing the two securing screws at the
connection of the Hook Plate to the Swing Arm (Figure 12):
 

Figure12
ForTVswithaverticallycentered(toptobottom)VESAholePattern,followsteps8–10.  Ifthe
VESAHolePatternisnotverticallycentered,skiptostep11. 
8. If the TV has a VESA hole pattern that is centered vertically, Configure the Extension Bars (B2)
as desired. If the TV display has a 100 mm x 100 mm or 200 mm x 200 mm VESA pattern,
the extension bars are not needed. Use the S1 and S2 screws to secure the Extension Bars
(B2) as shown in Figure 13.
400mm
400mm
480mm
200mm
200mm
480mm