User's Manual

Connection status：
1.Online status of the Transmitter break the connection：
When the receiver and the Transmitter has been in connection line status, if connection is cut, the
Transmitter will return into the search mode, Connection LED will flash with 1 Hz, Transmitter
connected or press comb key again, the receiver and the transmitter can be connected again.
2. Online status of the transmitter mandatory break the connection：
When the receiver and the transmitter has been in connection status, Press Comb key for 4
seconds , the transmitter will go into the search mode, the transmitter Status LED flashes to 2 Hz,
and the original receiver interrupted, the receiver will go to the connected Line mode, the
receiving end of the Status LED flashes to 1 Hz. As in the original transmitter into the search
mode of <10 seconds>between the transmitter is unable to obtain new lines connecting the
receiver, transmitter will go into sleep status. If the transmitter goes into search mode press the
button to connect Comb model line, then the receiving end with the completion of connecting
lines.
3. Receiver in the search mode of connection methods：
Receiver into the search mode, Connect LED flashes to 2 Hz, at this time, if more than
two-transmitters are entered, the registration or connecting line mode, the receiver will be
complete registration with any Transmitter which it has not Connected.
4. Transmitter in the search mode of connection methods：
Transmitter into the search mode, Status LED flashes to 2 Hz, at this time, if more than
two-receiver into the search mode, The transmitter will complete the register of the connection
with any receiver which it has not connected to before.
5. Re-plug the receiver connection：
When the receiver and the transmitter has been in connecting line status, such as receiver will be
inserted under the Wii Remote stuck again, this time receiver turn into the search mode, Connect
LED flashes to 1Hz, the Transmitter part has also entered search mode, Status LED 1 Hz will
flicker, at this time need press the comb keys for 4 seconds and will automatically make the
Transmitter into the search mode to connect with the receiver line registration or wait for the
transmitter dormancy mode then click Comb awakened transmitter and receiver can be connected
to re-register line.
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1)this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC NOTE:
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.