Instructions / Assembly

EC0635 / EC0636 ASSEMBLY INSTRUCTIONS
Components List
Item
Description
Quantity
A
Rattan Shade
1
B
Socket Collar Ring
1
C
Bulb (Not included)
1
D
Lamp Holder
1
E/F/G
Articulation Point
3
H
Canopy
1
I
Mounting Bracket
1
J
Wire Connector
3
Hardware List
Item
Description
Quantity
a
Canopy Mounting Knobs
2
b
Long Screws (1.25”)
2
WARNING: TO AVOID THE RISK OF ELECTRICAL SHOCK, BE SURE TO TURN OFF MAIN POWER PRIOR
TO INSTALLATION.
ASSEMBLY STEPS
1. Remove fixture and components from packaging.
2. Install Mounting Bracket (I) to Junction box using Long Screws (b).
3. Connect the Ground wire from the fixture and canopy to junction box, secure the electrical connections using the
wire connector (G). Connect the NEUTURAL (OR WHITE) WIRE from the fixture to NEUTRAL WIRE from power supply
with the wire connector (G). Connect the HOT (OR BLACK) WIRE from fixture to BLACK WIRE from power supply with
the wire connector (G).
4. Lift Canopy and fixture up and on to the Mounting Bracket (H) and secure in place with Canopy Mounting Knobs (a).
5. Install Rattan Shade (A) onto the Lamp holder (D) and secure by Socket Collar Ring (B) until tight.
6. Install desired bulb on Lamp holder (D).
7. Adjust the desired angle by moving the Articulation Point (E/F/G) up and down by loosening the tension on the wing
nut section of the Articulation Point.
CAUTION - Refer to the wattage caution label located near the socket for rated maximum wattage-do not exceed
maximum wattage specification.
Note: (1). The above diagram illustrates the installation of your new light fixture. This is a representative drawing and is
not intended to match the style of your light fixture.