Operation Manual

6-16
Storex DNR-30H Network Camera
Date SetupRecording Setup
Recording Setup
In addition to the capability of storing event snapshots to local SD Card slot (card not included), this camera
also supports storage of video clips (audio may be included if enabled) to the local storage device. To
congure the recording function, go to the main setup page and click [Recording Setup]. Then follow the
steps below.
1. Recording Setting: Here it displays the status of your SD card among other options. Click [Next] to
proceed.
SD Card Status Status verication
SD Card Capacity Show available and total space in the card
Format Click to format SD card
Enable Recording during
network failure
Check to allow forced recording to SD card when network
connection fails
Table 6-3. SD card setup
2. Event Selection: Click on [Next] to set up recording methods: "Event-based" or "Disable Recording."
Event-based Recording: Start recording when motion, audio and I/O are triggered (multiple choices).
Recording length: 60~3,600 sec, default 60 sec.
DisableRecording:Turnorecordingfunction.
Having made your settings, press [Save] button to save your settings. To playback the recordings stored on
the SD card, go to [Setup], and click on [Recording History] located on the left menu.
Note:
• ThisStorexIPcamerausesaFirstInFirstOutstoragemethod.Oncethe
SD card is full, the oldest le will automatically be overwritten.
• IfyouwanttorecordvideoclipsofdetectedmotiontoSDcard,you
need to set at least a motion detection region before setting up event-
based recording in "Recording Setup."
Recording History
Recording History lets you manage the video clips that have been recorded and stored on SD card by the
camera. You will also see a playback menu as shown below.
Figure 6-21. Recording history
Figure 6-22.
To play a video clip, rst select a video clip on the list and press [Playback]. (File format: AVI)