Operation Manual

6-11
Chapter 6: Conguration
Event SetupPTZ Control
Delete Preset Points
If you would like to delete a preset point, please select a preset point from the “Available Preset Points“
list. Before you press [Remove] to delete the selected preset point, you can click [Go To] button to move
the camera to the selected position and check the view in the preview window.
Figure 6-13. Delete preset points
PTZ Position Reset
Here it allows you to move the camera view to the preset position. There are two reset buttons:
• Calibrate PTZ Back to Factory Default - Press here to calibrate Pan/Tilt position back to factory
default.
• Reset PTZ Home Position Back to Factory Default - Press here to reset camera’s Home position to
factory default.
Figure 6-14. Delete preset points
Patrol Mode
Patrol Ordering
After you have created preset points, you could then congure how much time the camera will stay on
each preset position when in patrol mode. To set the patrol order, check and select preset positions from
the drop-down list, and then enter the duration for each checked and selected preset position. Pres [Save]
to apply settings.
Figure 6-15. Patrol ordering
Patrol Speed
Here you can congure the PTZ camera patrol speed to be fast, medium, or slow. After you have chosen a
speed setting, please press [Save] button.
Event Setup
When an event happens, like detected motion or triggered I/O device, a snapshot can be instantly sent to
your E-mail account, ftp server, image server, notication server, HTTP server, or SMS recipient to warn you
about what’s happened. In order to properly set up the event function, you must:
1. First set up the event server based on your needs: E-mail, FTP, Image or NVR Station Notication.