Operation Manual

6-9
Chapter 6: Conguration
Network SettingsNetwork Settings
RTSP server
Set the RTSP (Real-Time Streaming Protocol) port for your IP camera to enable the support of 3GPP
streaming for mobile phones. Default: 554. If you need to use port forwarding, please refer to the
troubleshooting section for port forwarding setup.
DDNS
ClickheretoenabletheDDNS(DynamicDomainNameService)serviceifyouareusingoating/dynamicIP
and want to tie your camera’s current IP address to a domain name. And instead of remembering a string of
IP address, you can use the easier-to-remember domain name to access your camera over the Internet. If you
already have an account with DynDNS or no-ip, you can also input its domain name here for easier access to
your IP camera.
UPnP
Check here to enable/disable the UPnP feature on your IP camera installed on your local network. Also, you
can change the device name here. If your operating system supports Universal Plug and Play (UPnP™) feature
and DHCP is in use on current network, the Storex IP camera will be automatically detected and added to My
Network Places on your Windows. If you want to use the IGD (Internet Gateway Device) protocol on your IP
camera, please check the [Enable IGD] box to enable it.
Note:
If you want to enable the UPnP™ service on your Windows, please
executethe“AddorRemovePrograms”itemfoundin“ControlPanel”,
andafter“AddorRemovePrograms”windowappears,clickon“Add/
RemoveWindowsComponents”anddouble-clickon“Networking
Services”itemandcheck“UPnPUserInterface”boxandproceedto
install the component.
RTP
If you want to broadcast video using RTP (Real-time Transport Protocol), you can set up the port range, video/
audio address and port number here.