Operation Manual

3-7
Chapter 3: Installtion
Installing Camera SoftwareInstalling Camera Software
6. Select the conguration of your IP address to
obtain IP address automatically (DHCP mode)
or manually enter IP address information.
Then choose whether to allow iWizard
to automatically configure your firewall,
congure connection port and the frequency
of your local power. (Note if you enabled
Seedonk service, you won’t see connection
port and frequency conguration here.)
Figure 3-9. Device conguration
7. Select the orientation of your IP camera in
Standard Position or Ceiling Mount. You can
also change the orientation setting later via
the Web client.
Figure 3-10. Orientation conguration
8. (If you are not using wireless connection,
please skip this part) If you have purchased
and connected the Storex wireless adapter
to your IP camera, you will come to wireless
network setup. Please click[Yes] to connect
wirelessly by default. The wizard will search
for available access points. Then select one
access point.
Figure 3-11. Wireless connection setup