Operation Manual

3-5
Chapter 3: Installtion
Installing Camera SoftwareInstalling Camera Software
Running the iWizard Setup Utility
Before running Storex software, make sure you have Storex IP Camera beside you. To begin setup, insert the
installation CD supplied with the camera into your CD-ROM drive, and the iWizard utility will start and guide
you during the installation process of the hardware and software for your IP camera. You will be asked to
select the displayed language rst. Then please click on [IP Camera Setup] and select the camera you wish to
install, and follow the steps below.
Note:
If Autorun has been disabled in your computer, please browse the
contents of the installation CD and double-click on the "iWizard.exe" le
to run the setup wizard.
1. The wizard searches for all available cameras
on your local network. Click on a camera from
connected camera list, and wait until the live
video and camera information are displayed
on the right side. (You can double-check
the device name and the MAC ID which are
printed on the serial number sticker at the
back of IP camera and on the package). Then,
click [Next].
Figure 3-4. Camera selection
2. Meanwhile, if you see the Windows Security
Alert dialog box during the search, please
choose [Unblock]..
Figure 3-5. Security alert dialog (Windows XP)