Operation Manual

3-1
Chapter 3: Installtion
Connecting the Cables<頁頁頁頁頁頁>
Chapter 3: Installation
Connecting the Cables
The picture below shows the basic connection of your IP camera.
Figure 3-1. Connection of cables
LAN cable from PC to hub/router: If your LAN cable from PC has been connected to the Cable/ADSL
modem, please re-connect it to the Ethernet port of your hub/router.
Ethernet port on camera: Use the bundled RJ-45 LAN cable to connect the Ethernet port of the IP
camera to the Ethernet port of your hub/router.
Wireless adapter (Optional accessory): If you have purchased the Storex USB wireless adapter for
wireless connection, please plug it into the USB port of IP camera for wireless reception.
Power: Attach the power adapter to the camera’s power connector and connect the power plug to a
power outlet.
Caution!
• ThewirelessconnectionportonlysupportstheStorexwireless
adapters;pleasedonotuseotherUSBadaptersonStorexIPcamera.
Should you remove the wireless adapter during camera operation, you
needtopowerothecamerarstbeforere-pluggingit.
• PleasedonotrotateyourIPcamerabyhand.Itmaycausethedamage
of the IP camera.
• Whenyouunplugthepowerplugfromthewalloutletwhilethe
camera is still in operation, wait for 4 seconds before plugging the
power plug back in the wall outlet. And avoid too frequent plugging
and unplugging of power cable.