Operation Manual

2-4
Storex DNR-30H Network Camera
<頁頁頁頁頁頁>LED Status Indicator
LED Status Indicator
The LED status indicator comprises a blue LED and a red LED. When you turn on the power of IP camera, the
camera will start booting procedure. The IR LEDs and LED status indicator will be lit in the following patterns:
1. A few seconds after the IP camera powers on, the IR LEDs and LED status indicator becomes lit. The IR
LEDs appears red.
2. Afterabout5moreseconds,theIRLEDsturnso.
3. Attempting to connect: Establishing connection takes about 60 seconds. After the connection is
established, the blue LED will remain lit.
4. Connection established: LED status indicator remains lit in blue.
5. Connectionfailed:BlueLEDlightashingonando.
Red LED Blue LED Indication
On
On
System booting up
O
On
Successfully established network
connection
On
O
Performing hardware test
O
O
Poweredo
Blinking (every 0.5 sec.)
O
Failed to connect to network / failed to
establish a WPS connection
O
Blinking (every 0.5 sec.)
Attempting to establish a WPS connection
O
Blinking (every 0.2 sec.
in a 3-second period)
Successfully established a WPS connection
Blinking (every 0.5 sec.)
Blinking
Attempting to establish network
connection
Table 2-1. LED status
Figure 2-3. IR LEDs (left) and LED status indicator (right)