Use and Care Manual
14 15
HOW TO USE YOUR PANCAKEBOT
7. Connect the Air Hose to the Dispenser Bottle Fill
Cap. The other end should be connected to the
Gantry. If not, please do so. The Air Hose insertion
point on the Gantry is location on the back side of
the PancakeBot, just above the Main Leg.
8. Lift the Cable Connector Lid and attach the
Gantry Cable to the Cable Connector. You may
hear a faint click as the tab locks into place. When
disconnecting the Gantry Cable, press on the top
of the small tab on the Gantry Cable and then pull
upwards.
9. Run the cable at against the top left of the housing
and close the Cable Connector Lid.
10. Insert the Electric Probe into the Griddle and the
Power Cable into the back of the PancakeBot. Plug
both cables into a power source.
HOW TO USE YOUR PANCAKEBOT
LOADING THE BATTER
For optimal performance, please follow the instructions on pg. 15 on making your
batter. To ensure that the batter is clump-free, strain the batter before loading into
the Dispenser Bottle. We recommend that you remove the Dispenser Bottle from
the PancakeBot before lling so that batter does not leak onto the Griddle.
Watch the “How To” video on www.pancakebot.com to learn step by step.
1. Unscrew the Dispenser Bottle Fill Cap and remove the Dispenser Bottle from
the Dispenser Holder. Attach the Drip Cap to the tip of the Dispenser Bottle
Nozzle.
2. Fill the Dispenser Bottle with batter. Do not ll past the MAX line.
WARNING: Do not overll the Dispenser Bottle or tilt the Dispenser Bottle
while it is connected to the Air Hose and the PancakeBot is turned on. If you
see pancake batter entering the Air Hose, disconnect the Hose from the
Gantry and shut the PancakeBot off immediately. Thoroughly clean and dry
the Air Hose before reconnecting.
3. Screw the Dispenser Bottle Fill Cap back onto the Dispenser Bottle and attach
the Air Hose.
4. Slide the Bottle into the Dispenser Holder, aligning the Dispenser Bottle Spine
with the shortest Height Adjustment Slot. The shortest slot is for standby and
holds the batter furthest from the Griddle whereas the longest slot will be
used for printing. If you are using a taller griddle, you can use the shortest
slot for printing. Do not remove the Drip Cap until you have turned on the
PancakeBot.
Long Slot
Short Slot