Use and Care Manual

12 13
SET TING UP
The PancakeBot disassembles for easy storage and consists of 5 main parts:
• PancakeBot Base
• Gantry
• Support Leg
• Dispenser Bottle and Cap
• Griddle*
* IMPORTANT NOTE ABOUT YOUR GRIDDLE: If you would like to purchase a new
griddle or are an international Kickstarter backer that did not receive a Griddle,
the griddle you purchase should be no wider than 12” and no taller than 2.5”. You
may need to alter the legs or base of your griddle to line up with the PancakeBot
Base. Depending on the height of your new griddle, you may also need to use a
different Height Adjustment Slot when printing.
1. Place the PancakeBot on a stable, at surface.
2. Slide the Support Leg into the slot on the
underside of the Gantry, opposite the Main Leg
Connectors. The at surface should be facing
outwards.
HOW TO USE YOUR PANCAKEBOT
3. Hold the Gantry upright and align the two
Main Leg Connectors with the two holes on the
PancakeBot Base Main Leg. Make sure that the
Support Leg lines up with the groove on the
opposite side of the Main Leg on the PancakeBot
Base.
4. Slide the Gantry all the way to the opposite side
of the Control Panel.
5. Place the Griddle on the PancakeBot Base* (see
note on pg. 8 if you did not receive a griddle with
your PancakeBot). Make sure to place the legs
within the stoppers located on the PancakeBot
Base. The Probe Socket should be facing the
back of PancakeBot (away from the Control
Panel).
6. Slide the Dispenser Bottle with Fill Cap attached
into the Dispenser. Make sure to align the
Dispenser Bottle Spine with the appropriate
Height Adjustment Slot (the shortest slot is for
standby and the longest slot is for printing).
HOW TO USE YOUR PANCAKEBOT