StorCase® Technology Data Express® Ultra320 DE100 Removable SCSI Ultra320 Drive Enclosure with 80-Pin SCA Interface User's Guide
i StorCase® Technology Data Express® Ultra320 DE100 Removable SCSI Ultra320 Drive Enclosure with 80-Pin SCA Interface User's Guide Part No. D89-0000-0240 A00 September 2003 StorCase Technology, Inc. 17600 Newhope Street Fountain Valley, CA 92708-9885 Phone (714) 438-1850 Fax (714) 438-1847 Ultra320 DE100 User's Guide - Rev. A00 StorCase Technology, Inc.
ii LIMITED WARRANTY STORCASE TECHNOLOGY, Incorporated (StorCase) warrants that its products will be free from defects in material and workmanship, subject to the conditions and limitations set forth below. StorCase will, at its option, either repair or replace any part of its product that proves defective by reason of improper workmanship or materials.
iii Free Technical Support StorCase provides free technical support. If you experience any difficulty during the installation or subsequent use of a StorCase product, please contact StorCases Technical Support Department prior to servicing your system. This warranty covers only repair or replacement of defective StorCase products, as described above. StorCase is not liable for, and does not cover under warranty, any costs associated with servicing and/or installation of StorCase products.
iv Declaration of Conformity Company Name: StorCase Technology, Inc.
v Table of Contents INTRODUCTION .................................................................................................................... Packaging Information .................................................................................................. Serial Numbers .............................................................................................................. Package Contents .................................................................................................
vi List of Figures Figure 1: Figure 2: Figure 3: Figure 4: Figure 5: Figure 6: Figure 7: Figure 8: Figure 9: Figure 10: Figure 11: Package Contents .......................................................................................... 2 Ultra320 DE100 Receiving Frame and Carrier .............................................. 3 Receiving Frame (Front View) ...................................................................... 4 Receiving Frame Unit ID Number and Activity Display .......................
Introduction 1 INTRODUCTION Packaging Information The StorCase Technology Data Express® system is shipped in a container designed to provide protection and prevent damage during shipment. The Data Express unit was carefully inspected before and during the packing procedure at the factory. Bent or broken connectors, or evidence of other damage to the Data Express should be reported to the shipper immediately. Refer to Figure 1 for the package contents.
2 Introduction Package Contents The DE100 package contents include the following items. If any item is missing or damaged, contact your StorCase dealer for a replacement. Da ID Drive Disk (Not Drive Inclu ded) Pow er I/O Cabl Cable e ta E xpre ss Cabl Cove (Pro r e vided ) Sele ct Cabl e Carr ier Drive Hard Phill 3/16 ips wareMounting Flat # 6-32(4ea HD x ) 0151 Cabl Scre e # Flat 6-32 ws (2Cove HD x 3/16plcs)r 0430i 7 8 1. #6-32 x 1/4 Phillips Pan Head Mounting Screws 5. Insert Sheet 2.
Introduction 3 General Description NOTES: For SCSI Ultra320 operation, the Ultra320 DE100 requires Ultra320 drives, Ultra320 HBA, and Ultra320-compliant cabling (internal and external). Ultra320 DE100 can support Ultra320 implementations with a maximum of fifteen (15) Ultra320 drives (Ultra320 repeater may be required). Ultra320 DE100 receiving frames are indicated by their BLUE LED, while the Ultra320 DE100 carriers are indicated by the Ultra320 logo.
4 Introduction Receiving Frame Front Panel (Figure 3) Key Lock/Drive Power Switch - This key switch assures proper seating of the drive carrier within the receiving frame, turns power to the drive carrier ON and OFF, and prevents unauthorized removal or installation of the carrier. For the computer to access data on the disk drive, the key must be turned counterclockwise to the locked position. The key can be permanently attached to the locking mechanism as shown in Appendix C.
Introduction 5 Carrier Removed from Receiving Frame Carrier Installed (unlocked) Carrier Installed (locked) Activity Indicator 0064c Fan Failure The number "2" shown above is for illustration purposes only. It can be any valid unit ID number. The letter "u" and F will appear as illustrated. Figure 4: Receiving Frame Unit ID Number and Activity Display Receiving Frame Rear Panel (Figure 5) DC Power Connector (P1): The Ultra320 DE100 uses a standard 4-pin DC power connector to accept DC power.
6 Introduction Factory-Installed Jumpers: There are two (2) jumpers factory-installed on W1. These jumpers are located on Pins 9 & 10, and Pins 19 & 20. NOTE: Do not remove these jumpers! DC Power Connector (P1) 68-Pin I/O Connector (J3) Buzzer J3 P1 Option Pin Connector (W1) 0456J P17 P18 9 10 17 19 18 20 Factory-Installed Jumpers (Do Not Remove!) Figure 5: Receiving Frame Motherboard (Rear View) StorCase Technology, Inc. Ultra320 DE100 User's Guide - Rev.
Installation 7 INSTALLATION NOTES: For SCSI Ultra320 operation, the Ultra320 DE100 requires Ultra320 drives, Ultra320 HBA, and Ultra320-compliant cabling (internal and external). Ultra320 DE100 can support Ultra320 implementations with a maximum of fifteen (15) Ultra320 drives (Ultra320 repeater may be required). Ultra320 DE100 receiving frames are indicated by their BLUE LED, while the Ultra320 DE100 carriers are indicated by the Ultra320 logo.
8 Installation Drive (Not Included) Drive Carrier Board Drive Carrier 0151d #6-32 x 1/4 Phillips Flat Head Screw (4 each) Figure 6: Drive Installation Assembly 1 Insert this end into the carrier first 2 Slide the cover towards the back of the carrier 0823 3 Secure with two (2) #6-32x1/4 Phillips Flat Head screws. Figure 7: Drive Cover Installation StorCase Technology, Inc. Ultra320 DE100 User's Guide - Rev.
Installation 9 Installing the Receiving Frame The drive should be installed into the carrier before installing the receiving frame into the mounting bay of a computer or expansion chassis. A #2 Phillips screwdriver will be required for installation. 1. Turn OFF power to the computer. 2. Open the computer system according to the manufacturers instructions. If necessary, temporarily remove any expansion boards that may make installation difficult. 3.
10 Installation Table 1: Option Pin Connector (W1) Signal Descriptions PIN Signal Function 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 ID0 GND ID1 GND ID2 GND ID3 GND FFAULT FFAULT SYNC GND RMST GND DYST GND RLED RLED FAN1 FAN2 Reserved Reserved SCSI ID Ground SCSI ID Ground SCSI ID Ground SCSI ID Ground Fan Fault LED/Alarm Enable* Fan Fault LED/Alarm Enable* Drive Synchronous Signal Ground Remote Start (see Table 2) Ground Delay Start (see Table 2) Ground Remote LED Cathode Remote LED An
Installation 11 4. With the drive carrier locked into place inside the receiving frame, install the Ultra320 DE100 receiving frame into the drive bay in the computer or expansion chassis. Use the appropriate guides to position the Ultra320 DE100, and fasten it into place with the four (4) #6-32 Phillips screws provided. Figure 9 illustrates the location of the mounting holes.
12 Installation 7. Connect the power cable from the DC power supply in the computer or expansion chassis to the power connector on the Ultra320 DE100 receiving frame. Refer to Figure 5 for the receiving frame power connector location. 8. Replace any expansion boards that may have been removed earlier. Replace the system cover according to the manufacturers instructions. 9. Reconnect any system or peripheral cables removed earlier. 10. Turn ON power to the computer.
Installation 13 5. The new drive may need to be formatted or initialized prior to use with the operating system and applications software. Refer to the drive and computer manufacturer's documentation for formatting information. Unit ID Number Display ID Select Rotating Switch 0179d Figure 10: Unit ID Select Switch Location Ultra320 DE100 User's Guide - Rev. A00 StorCase Technology, Inc.
14 Installation Adjusting the Spin Down/Up Timer NOTE: The timer for device spin down is controlled by a small selector, located in a cutout on the side of the Ultra320 DE100 receiving frame as shown in Figure 11. The amount of time required for a drive to spin down is approximately 15 seconds or more. This number can vary depending on the type of SCSI device and manufacturer (some drives may require 45 seconds or more). The factory configuration is set for 20 seconds.
Appendix A - Specifications/Dimensions 15 APPENDICES Ultra320 DE100 User's Guide - Rev. A00 StorCase Technology, Inc.
16 Appendix A - Specifications/Dimensions Appendix A - Specifications/Dimensions SCSI Data Express subsystems conform to the Small Computer Systems Interface (SCSI) Standard set by the American National Standards Institute (ANSI).
Appendix A - Specifications/Dimensions 17 1.70 (43.2mm) 7.93 (201.4mm) 5.75 (146.1mm) 5.50 (139.7mm) 3.13 (79.4mm) 0.25 (6.4mm) 1.68 (42.5mm) 0.15 (3.8mm) 7.38 (187.5mm) 4.67 (118.6mm) 0285c Figure A-1: Ultra320 DE100 Physical Dimensions (Dimensions are for reference only) Ultra320 DE100 User's Guide - Rev. A00 StorCase Technology, Inc.
18 Appendix B - Attaching the ON/OFF Key Appendix B - Attaching the ON/OFF Key The following information describes the necessary steps to attach the ON/OFF key to the key lock mechanism so that it is non-removable, preventing accidental key loss. The procedure can be reversed at a later date to revert back to a removable key. 1. Make certain power is OFF to the receiving frame. Locate the rectangular-shaped key lock mechanism access hole on the inside of the receiving frame.
Appendix C - Field-Replacing the Carrier Fan 19 Appendix C - Field-Replacing the Carrier Fan NOTE: A #2 Phillips screwdriver will be required during this procedure. While performing steps in this section, work on a soft surface to prevent excessive shock to the drive and carrier.
20 Appendix C - Field-Replacing the Carrier Fan Fan Fan Bracket 0826b Phillips Head Screws (4 per Fan) Figure C-2: Replacing the Fan 1. Carefully uninstall drive (if still installed in carrier). Refer to section "INSTALLATION" for further information. 2. To remove fan, loosen and remove the three (3) #6-32 Phillips Head screws securing the fan bracket to the drive carrier (Figure C-1). 3. Carefully remove the fan bracket, making sure to disconnect the fan power cable from the drive carrier. 4.
Appendix D - Optional Accessories 21 Appendix D - Optional Accessories Carrying Case 320FW_13 Figure D-1: Carrying Case The optional molded plastic carrying case (P/N S20E104) is designed to transport the Ultra320 DE100 carrier from one site to another in a safe, impact and moisture resistant environment. Its compact design, makes it easy to carry and to store. Contact your StorCase dealer for further details and ordering information. Ultra320 DE100 User's Guide - Rev. A00 StorCase Technology, Inc.
22 Appendix D - Optional Accessories This Page Left Blank Intentionally. StorCase Technology, Inc. Ultra320 DE100 User's Guide - Rev.
23 Reader's Comments Reader's Comments Please take a few moments when your computer system is up and running to send us your ideas and suggestions for improving our products and documentation.
CUT ALONG THIS LINE FROM BOTTOM TO TOP OF PAGE FOLD ALONG THIS LINE AND STAPLE SHUT NO POSTAGE NECESSARY IF MAILED IN THE UNITED STATES B U S I N E S S R E P LY M A I L FIRST CLASS MAIL PERMIT NO. 10686 SANTA ANA, CA POSTAGE WILL BE PAID BY ADDRESSEE TECHNOLOGY CORPORATION 17600 NEWHOPE STREET FOUNTAIN VALLEY CA 92708-9885 StorCase Technology, Inc. Ultra320 DE100 User's Guide - Rev.
