Owner's manual

StorCase Technology, Inc.RJR110 Users Guide - Rev. A02
7
INSTALLATION
NOTES: A #1 and #2 Phillips screwdriver will be required for this procedure.
RJR110 supports implementations with a maximum of 2 drives per channel.
68-Pin SCSI Version
1. Remove cover from the carrier by turning screw clockwise. Slide the cover off
carrier (Figure 4).
2. Carefully insert drive (not included) into the carrier. Slide the drive towards the rear
of the carrier so that the drive connectors can mate with the carrier connectors.
Once the drive and carrier are mated, turn the drive/carrier assembly over.
3. Bottom-mount the drive into the carrier with four (4) Phillips screws (Figure 5).
Reinstall cover onto the carrier.
Secure the cover by turning the screw counterclockwise a few rotations only. Do
not turn the screw too many times in a counterclockwise direction or the screw
will be removed.
Turn Screw
Clockwise
Slide Cover
Off
1
2
Close-Up
View of Screw
Figure 4: Cover Removal