Instruction Manual
StorCase Technology, Inc. FJR100 Users Guide - Rev. C00
6
Signal Row
Black (ID0)
Brown (ID1)
Red (ID2)
Orange (ID3)
Black (GND)
GND Row
Figure 5: 16-Bit SCSI ID Cable Connection
For Hard Drives:
(Figure 4)
1. Connect the 4-pin DC power cable to the drive.
2. Connect the 5-wire ID select cable to the drive (Figure 5).
3. Attach I/O plates (not included) to the RhinoJR chassis (as shown in
Figure 4).
4. Connect the I/O cable to the drive.
5. Attach the drive mounting brackets to the drive. Install the drive/mount-
ing bracket assembly into the chassis and bottom mount with four (4)
#6-32 screws (included) as shown.
6. Re-install the cover onto the chassis.