Instruction Manual

StorCase Technology, Inc. FJR100 Users Guide - Rev. C00
4
INSTALLATION
Removing the RhinoJR Cover
While performing the steps in this section, work on a soft surface to prevent excessive
shock to the drive being installed. Also refer to the manufacturers documentation provided
with the drive. Phillips #1 and #2 screwdrivers will be required during this procedure.
CAUTION:
Remove ALL power from the RhinoJR before removing the cover. The RhinoJR contains NO
USER SERVICEABLE PARTS inside the unit.
1. Unplug the RhinoJR and verify that all cables have been disconnected.
2. Remove the four (4) screws located underneath the chassis (Figure 3).
3. Carefully slide the cover rearward off the chassis.
Figure 3: Removing the Cover