Manual

6 Introduction
StorCase Technology, Inc. SATA-to-USB 2.0 DE110 User's Guide - Rev. A00
Figure 5A: Receiving Frame Motherboard
(Rear View)
ReceivingFrameRearPanel
(Figures 5A & 5B)
 USB Connector - Provides a standard interface for USB 2.0 signals.
 DC Power Connector (P1) - A standard 4-pin DC power connector is used to accept
DC power.
 Option Pins (W1) - Refer to Figure 5B.
ID0 & ID1 - Jumper is factory-installed on ID0. Change jumper position to Pins 3 & 4 for
ID1 designation. ID0 & ID1 are for ID display purposes only. Refer to Table 1 for further
information.
Remote Activity LED (RLED) - For PATA drives, these pins provide power for a remote
LED device activity indicator (Pin 13=Cathode, Pin 14=Anode).
 Factory Reserved Pins - These pins are reserved for factory use only - Do not install
jumper under any circumstances!
USB 2.0
Connector
Option Pin
Connector
Factory Reserved Pins
(No Jumper Installed)
DC Power
Connector