Owner manual

DE90i-S, Rev. A00 Kingston Technology Company
Installation 11
Installing the Receiving Frame
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis.
NOTE: Use a #2 Phillips screwdriver during this procedure.
1. Turn off power to the computer.
2. Open the computer system according to the manufacturer’s instructions. If
necessary, temporarily remove any expansion boards that may make installation
difficult.
3. Select the unit ID number on the rear of the receiving frame by placing jumpers on
the appropriate (J4) pins. Refer to Figure 7 and to Table 3 for additional information.
Table 3 - Receiving Frame Mother Board Connector J4 Pin Configuration
Pin 1 RESERVED Pin 11 RESERVED
Pin 2 RESERVED Pin 12 RESERVED
Pin 3 RESERVED Pin 13 RESERVED
Pin 4 RESERVED Pin 14 RESERVED
Pin 5 RESERVED Pin 15 Ground
Pin 6 RESERVED Pin 16 ID2
Pin 7 RESERVED Pin 17 Ground
Pin 8 RESERVED Pin 18 ID1
Pin 9 RESERVED Pin 19 Ground
Pin 10 RESERVED Pin 20 ID0
Figure 7: SCSI ID Select Pin Configuration on Receiving Frame Mother Board (J4)
Ground
0419
Receiving Frame
Mother Board
Connector J4
Installed
at Factory
SCSI ID = 0
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
ID1
ID2
ID0
ID NUMBER
Reserved
19
20
113
214
ID0
ID1
ID2