User guide
6 Installation
StorCase Technology, Inc. DE90i-A66 User's Guide - Rev. A01
DE90i-A66INSTALLATION
InstallingtheDriveintheCarrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive
shock to the drive being installed. Also refer to the manufacturer's documentation
provided with the drive.
NOTE: A #2 Phillips screwdriver will be required during this procedure.
1. Remove the drive from its protective packaging.
2. Plastic Drive Bezel: If the drive came equipped with a plastic front bezel,
it must be removed before installing the drive into the drive carrier.
3. Master/Slave Drive Selection: In most cases, the drive will be factory-
configured as a Master Ultra ATA/66 drive using a jumper plug on the drive
itself. No configuration changes are required. For multiple drive
configurations, it is necessary to set the first Ultra ATA/66 drive as Master
and the second Ultra ATA/66 drive to Slave. This can be done by changing
the jumper on the Ultra ATA/66 drive itself (refer to your drive manufacturer
documentation).
Figure 4 : DE90i-A66 Drive Carrier Circuit Board