Owner's manual
Installation 9
DE75i-SWC160 User's Guide - Rev. B01 StorCase Technology, Inc.
Figure 7: Receiving Frame Motherboard Option Pin Connector
InstallingtheReceivingFrame
The drive should be installed into the carrier before installing the receiving frame into the mounting
bay of a computer or expansion chassis.
NOTE: Use a #2 Phillips screwdriver during this procedure.
1. Turn OFF power to the computer.
2. Open the computer system according to the manufacturers instructions. If necessary,
temporarily remove any expansion boards that may make installation difficult.
3. To select the DE75i-SWC160 unit ID remotely through the computer system or external
expansion chassis, the appropriate cable from the system must be connected to the
option Pins 1-8 on the rear of the receiving frame as shown in Figure 7.