Owner manual

DE75i-SWC User's Guide - Rev. B00 StorCase Technology Inc.
Appendix B - Factory-Installed Options 19
Figure B-1: Attaching the Hot Swap Board
Jumper Options
Most jumper options are configurable via the receiving frame motherboard (Figure 7). The
Hot Swap Board provides one configurable jumper, JP1 (Figure B-2). When installed
(factory default), this jumper disables onboard termination. If the DE75i-SWC will be
physically located at the end of a SCSI daisy chain, remove this jumper to enable
termination.