Owner manual
Installation 9
DE75i-SWC User's Guide - Rev. B00 StorCase Technology Inc.
InstallingtheReceivingFrame
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis.
NOTE: Use a #2 Phillips screwdriver during this procedure.
1. Turn OFF power to the computer.
2. Open the computer system according to the manufacturers instructions. If
necessary, temporarily remove any expansion boards that may make
installation difficult.
3. To select the DE75i-SWC unit ID remotely through the computer system or
external expansion chassis, the appropriate cable from the system must be
connected to the option Pins 1-8 on the rear of the receiving frame as shown
in Figure 7.
Figure 7: Receiving Frame Motherboard Option Pin Connector