Manual
StorCase Technology, Inc. DE75i-SW160 User's Guide - Rev. B00
10 Installation
InstallingtheReceivingFrame
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis.
NOTE: Use a #2 Phillips screwdriver during this procedure.
1. Turn OFF power to the computer.
2. Open the computer system according to the manufacturers instructions. If
necessary, temporarily remove any expansion boards that may make installation
difficult.
3. To select the DE75i-SW160 unit ID remotely through the computer system or
external expansion chassis, the appropriate cable from the system must be
attached to option Pins 1-8 on the rear of the receiving frame (Figure 8). Set the
unit ID to "0" for remote ID selection (Figure 10).
Figure 8: Receiving Frame Motherboard Option Pins
4. With the drive carrier locked into place inside the receiving frame, install the DE75i-
SW160 receiving frame into the drive opening in the computer or expansion chassis.
Use the appropriate guides to position the DE75i-SW160, and fasten it into place with
four (4) #6-32 x 1/4 screws provided. Figure 9 illustrates the location of the mounting
holes. Mounting holes are provided on each side and the bottom of the receiving frame
to accommodate a variety of mounting configurations. Use the mounting holes which
best suit the computer or expansion chassis configuration.