User Manual
10 Installation
StorCase Technology Inc. DE75i-A66 User's Guide - Rev. A00
4. With the drive carrier locked in place inside the receiving frame, install the
DE75i-A66 into the 5.25 drive opening in the computer or expansion chassis.
Use the appropriate guides to position the DE75i-A66, and fasten it into place
with the four (4) #6-32 x 1/4 screws provided. Figure 9 illustrates the
location of the mounting holes. Mounting holes are provided on each side and
the bottom of the receiving frame to accommodate a variety of mounting
configurations. Use the mounting holes which best suit the computer or
expansion chassis configuration. Note that bottom mounting holes require self
tapping screws (not provided).
InstallingtheReceivingFrame
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of the computer chassis.
NOTE: Use a #2 Phillips screwdriver during this procedure.
1. Turn OFF power to the computer.
2. Open the computer system according to the manufacturers instructions. If
necessary, temporarily remove any expansion boards that may make
installation difficult.
3. Select the Master/Slave configuration on the rear of the receiving frame by
placing jumper(s) on the appropriate (JP4) pins (Figure 8).
Figure 8: Typical Receiving Frame JP4 Master/Slave Jumper Settings