StorCase® Technology Data Express® DE50 Removable Ultra ATA100 Enclosure User's Guide
i StorCase® Technology Data Express® DE50 Removable Ultra ATA100 Drive Enclosure User's Guide Part No. P89-0000-0167 E00 April 2006 StorCase Technology, Inc. 17600 Newhope Street Fountain Valley, CA 92708-9885 Phone (714) 438-1850 Fax (714) 438-1847 PATA DE50 User's Guide - Rev. E00 StorCase Technology, Inc.
ii LIMITED WARRANTY STORCASE TECHNOLOGY, Incorporated (“StorCase”) warrants that its products will be free from defects in material and workmanship, subject to the conditions and limitations set forth below. StorCase will, at its option, either repair or replace any part of its product that proves defective by reason of improper workmanship or materials.
iii Warranty Claim Requirements To obtain warranty service, the defective product must be returned to your local authorized StorCase dealer or distributor, or, with prior StorCase approval, to the StorCase factory service center. For defective products returned directly to StorCase, a Return Material Authorization (“RMA”) number must be obtained by calling StorCase Customer Service at (714) 445-3455. The RMA number must be prominently displayed on the outside of the return package.
iv Declaration of Conformity Company Name: StorCase Technology, Inc.
v Table of Contents INTRODUCTION ........................................................................................................................ Packaging Information ................................................................................................... Serial Numbers ............................................................................................................... Package Contents ..........................................................................................
vi List of Figures Figure 1: Figure 2: Figure 3: Figure 4: Figure 5: Figure 6: Figure 7: Figure 8: Figure 9: Figure 10: Figure 11: Figure 12: Figure 13: Package Contents .............................................................................................. 2 DE50 Receiving Frame and Carrier ................................................................... 3 Receiving Frame Front Panel .............................................................................
Introduction 1 INTRODUCTION Packaging Information The StorCase Technology Data Express® system is shipped in a container designed to provide protection and prevent damage during shipment. The Data Express unit was carefully inspected before and during the packing procedure at the factory. Bent or broken connectors, or evidence of other damage to the Data Express should be reported to the shipper immediately. Refer to Figure 1 for the package contents.
2 Introduction Package Contents NOTES: Package contents may vary, depending on model. Some DE50 models do not include a 5.25" adapter bracket. The DE50 package contents include the following items. If any item is missing or damaged, contact your StorCase dealer for a replacement.
Introduction 3 General Description NOTE: For Ultra ATA100 (100MByte/sec) operation, an Ultra ATA100 controller and hard drive(s), and appropriate 40-pin, 80-conductor cable are required. The StorCase Technology Parallel ATA Data Express® DE50 is a removable drive carrier and receiving frame, designed to provide durable and reliable mounting for one (1) 2.5" Ultra ATA100 drive within a 3.5" or 5.25" peripheral slot (with factory-installed adapter bracket).
4 Introduction Receiving Frame Front Panel (Figure 3) • Unit ID Number Indicator - This LED displays the physical address of the DE50 device carrier if the carrier is Installed and Locked in the receiving frame or if the carrier is removed from the receiving frame. If the carrier is Installed but not Locked in the receiving frame, a "u" will be displayed to indicate an unlocked condition.
Introduction 5 Figure 4: Receiving Frame Unit ID Number and Activity Display Receiving Frame Rear Panel (Figure 5) • I/O Connector (JP1) - The input/output connector provides a standard interface for all IDE signals. • DC Power Connector (P1) - A standard 4-pin DC power connector is used to accept DC power. • Master/Slave Selection Jumper (J2) - Master Drive configuration (Factory De fault). Change jumper position to set Slave Drive configuration (Figure 5).
6 Introduction I/O Connector JP1 J2 P1 0846 = Pin 1 J2 Slave Drive Select (1) DC Power Connector Master Drive Select (0) (Factory Default) Figure 5: Receiving Frame Motherboard (Rear View) StorCase Technology, Inc. PATA DE50 User's Guide - Rev.
Installation 7 INSTALLATION NOTE: A #1 Phillips screwdriver will be required during this procedure. Preparation While performing the steps in this section, work on a soft surface to prevent excessive shock to the drive being installed. Also refer to the manufacturer's documentation provided with the drive. 1. Remove the drive from its protective packaging. 2.
8 Installation 2. Disassemble the drive carrier unit into its three (3) main components as shown in Figure 7 (the drive carrier unit is shipped pre-assembled). Drive Carrier Circuit Board Top Cover Drive Mounting Bracket/Bottom Plate Assembly Figure 7: Drive Carrier Components 3. Install the Drive Carrier Circuit Board (cable-side down) onto the drive by attaching the I/O cable on the board to the drive (Figure 8). Drive Carrier Circuit Board (Cable-side Down) 2.
Installation 9 NOTE: The information below is based on typical drive specifications. Since specifications (specifically, pin assignments) between drive manufacturers may vary, please refer to your drive manufacturer's documentation for information regarding Master/Slave configuration. 4. There are two ways to set the Master/Slave drive designation for the DE50 unit, as described below.
10 Installation I/O Connector J1 JMP1 JP1 Master/Slave Jumper Option 0849a A B C D Cable Select Configuration Jumper Installed on Pins B & D (Factory Default) A B C D Recommended Configuration Typical Master Drive Configuration No Jumper Installed or A B C D Typical Slave Drive Configuration Jumper Installed on Pins C & D Figure 9: Drive Carrier Circuit Board 5. Carefully turn the drive/circuit board assembly upside-down (drive is bottommounted into bracket).
Installation 11 M3 Phillips Flat Hd. Screw (4 Total) Circuit Board NOTE: Make sure the circuit board is properly seated in the bracket slot before securing drive to the bracket assembly. Front Figure 10: Drive Mounting Bracket Installation 6. Carefully insert the drive/bracket assembly into the top cover and secure with four (4) M3 screws (saved from Step 1) as shown in Figure 6. PATA DE50 User's Guide - Rev. E00 StorCase Technology, Inc.
12 Installation Installing the Receiving Frame NOTES: Use a #2 Phillips screwdriver for this procedure. Some DE50 models do not include a 5.25" adapter bracket. The drive should be installed into the carrier before installing the receiving frame into the mounting bay of a computer or expansion chassis. 1. Turn OFF power to the computer. 2. Open the computer system according to the manufacturer’s instructions. If necessary, temporarily remove any expansion boards that may make installation difficult.
Installation 13 Bottom-mount Unit with Provided Self-Tapping Screws (4 Total) or 0863 Side-mount Unit with Provided Self-Tapping Screws (2 per Side) Figure 12: Adapter Bracket Mounting Holes for 5.25" Peripheral Slots Front of Unit Mounting Holes (Left Side) 0856 Mounting Holes (Right Side) Mounting Holes (Bottom) Figure 13: Receiving Frame Mounting Holes for 3.5" Peripheral Slots PATA DE50 User's Guide - Rev. E00 StorCase Technology, Inc.
14 Installation 5. Connect the I/O cable from the host adapter to the receiving frame. The Pin 1 indicator on the cable must be properly aligned. Refer to Figure 5 for the correct Pin 1 location. 6. Connect the power cable from the DC power supply in the computer or expansion chassis to the power connector on the DE50 receiving frame. Refer to Figure 5 for the DE50 receiving frame power connector location. 7. Replace any expansion boards that may have been removed earlier.
Installation 15 NOTE: The lock on the DE50 receiving frame functions as a lock and a DC power switch for the carrier unit. The lock must be engaged in order to supply power to the carrier and installed drive. 5. Reboot the computer. The new disk is now ready for use, although it may have to be formatted or initialized prior to use with your operating system and applications software.
16 Installation AT/IDE Interface Connector JP1 The AT/IDE Interface Connector (JP1) pin assignments are as follows: Table 2: AT/IDE Interface Signals Pin 01 03 05 07 09 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 Signal Host ResetHost Data 7 Host Data 6 Host Data 5 Host Data 4 Host Data 3 Host Data 2 Host Data 1 Host Data 0 Ground Reserved HIOWHIORReserved Reserved IRQ 14 Host ADDR 1 Host ADDR 0 Host CS0DASP- I/O O I/O I/O I/O I/O I/O I/O I/O I/O O O I O O O Notes Pin 02 04 06 08 10 12 14 16 18 20
Appendix A - Specifications/Dimensions 17 APPENDICES PATA DE50 User's Guide - Rev. E00 StorCase Technology, Inc.
18 Appendix A - Specifications/Dimensions Appendix A - Specifications/Dimensions The following specifications and dimensions apply to both ruggedized and non-ruggedized versions of the DE50. Specifications and dimensions are for reference only.
Appendix A - Specifications/Dimensions 19 The following specifications apply to the ruggedized version of the DE50 (P/N S20B120) only. Contact StorCase for further information regarding this particular DE50. Vibration Specifications Operating Storage 5 to 500 Hz Acceleration 5 to 500 Hz 0.3 g X, Y, Z axis Random Random Duration 10 min. per axis 10 min. per axis Shock Specifications Operating Frequency Duration Acceleration 2.4 g < 3ms 125 g 0860A PATA DE50 User's Guide - Rev.
20 Appendix A - Specifications/Dimensions Receiving Frame with Carrier Installed 1.01 (25.7mm) 0.18 (4.6mm) 4.01 (101.9mm) 1.02 (26.0mm) 2.36 (60.0mm) 1.18 (30.0mm) 2.75 (69.9mm) 3.71 (94.2mm) 5.65 (143.5mm) Carrier Only 2.89 (73.4mm) 0.95 (24.1mm) 5.04 (128.0mm) 2.96 (75.2mm) 0857 Figure A-1: DE50 Physical Dimensions (Dimensions are for reference only) StorCase Technology, Inc. PATA DE50 User's Guide - Rev.
Appendix A - Specifications/Dimensions 21 5.25 Adapter Bracket NOTE: Some DE50 models do not include a 5.25 adapter bracket. 1.68 (42.7mm) 0.47 (12.0mm) 5.82 (147.8mm) 0.39 (10.0mm) 2.09 (53.0mm) 3.12 (79.2mm) 5.73 (145.5mm) 5.48 (139.2mm) Figure A-2: DE50 Adapter Bracket Physical Dimensions (Dimensions are for reference only) PATA DE50 User's Guide - Rev. E00 StorCase Technology, Inc.
22 Appendix B - Optional Accessories Appendix B - Optional Accessories DE50 USB 2.0 Docking Station The Data Express DE50 USB 2.0 Docking Station (P/N S21B124) allows a PATA DE50 drive carrier to be docked for external use with a PC. Kit comes with carrier dock and split-USB 2.0 cable. An AC Power Adapter (P/N S21B129) and International Power Adapter Converter Kit (P/N S21B128) is available as an option. Contact StorCase for further ordering information. Split USB 2.
Appendix B - Optional Accessories 23 Carry Case The optional molded plastic carrying case (P/N S20E104) is designed to transport one (1) DE50 carrier from one site to another in a safe, impact and moisture-resistant environment. Its compact dimensions, 10” long x 11” wide x 4.5” high, make it easy to carry and to store. The foam lining is contoured to fit a single Data Express carrier. Contact your StorCase dealer for further details and ordering information.
24 Appendix B - Optional Accessories This Page Left Blank Intentionally. StorCase Technology, Inc. PATA DE50 User's Guide - Rev.
Reader's Comments 25 Reader's Comments Please take a few moments when your computer system is up and running to send us your ideas and suggestions for improving our products and documentation.
Reader's Comments CUT ALONG THIS LINE FROM BOTTOM TO TOP OF PAGE 26 FOLD ALONG THIS LINE AND STAPLE SHUT NO POSTAGE NECESSARY IF MAILED IN THE UNITED STATES B U S I N E S S R E P LY M A I L FIRST CLASS MAIL PERMIT NO. 10686 SANTA ANA, CA POSTAGE WILL BE PAID BY ADDRESSEE TECHNOLOGY CORPORATION 17600 NEWHOPE STREET FOUNTAIN VALLEY CA 92708-9885 StorCase Technology, Inc. PATA DE50 User's Guide - Rev.
