Owner manual

10 Installation
StorCase Technology, Inc. DE300i-SWC160 User's Guide - Rev. B00
PIN Signal Function
1 ID0 SCSI ID
2 GND Ground
3 ID1 SCSI ID
4 GND Ground
5 ID2 SCSI ID
6 GND Ground
7 ID3 SCSI ID
8 GND Ground
9 NC No Connect
10 GND Ground
11 RLEDA Remote LED Anode
12 RLEDC Remote LED Cathode
13 DFAULT Force Drive Fault Signal to Display
14 GND Ground
15 SYNC Drive Synchronization Signal
16 GND Ground
17 RMTST Remote Start
18 GND Ground
19 DLYST Delay Start
20 GND Ground
21 LKA For Factory Use Only
22 LKB For Factory Use Only
Table 1: J3A, J3B, J3C Option Pin Signal Descriptions
IMPORTANT NOTE: In order to use remote ID selection from the computer or ex-
pansion chassis, the Unit ID number on the Data Express re-
ceiving frame must be set to "0" with the provided alignment
tool. Refer to the section "Selecting the Unit ID Number" later
in this User's Guide for the Unit ID selection procedure.