Instruction Manual
Installation 9
DE200i-SWCU2 User's Guide - Rev. A01 StorCase Technology, Inc.
Figure 7: Receiving Frame Motherboard Option Pin Connector (W1)
InstallingtheReceivingFrame
NOTES: DE200i-SWCU2 requires LVD chassis and cabling.
DE200i-SWCU2 supports implementations with a maximum of 9 drives
(without the DX1/200-U2/RH Hot Swap/Repeater Isolator Board installed).
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis. A #2 Phillips screwdriver will be required
for installation.
1. Turn OFF power to the computer.
2. Open the computer system according to the manufacturers instructions. If
necessary, temporarily remove any expansion boards that may make installation
difficult.
3. To select the DE200i-SWCU2 unit ID remotely through the computer system or
external expansion chassis, the appropriate cable from the system must be
connected to the ID Select Pins 1-8 on the rear of the receiving frame as shown
in Figure 7.