User guide

Installation 9

DE100i-SWC160 User's Guide - Rev. D01 StorCase Technology, Inc.

Figure 8: Receiving Frame Motherboard Option Pin Connector (W1)

InstallingtheReceivingFrame

The drive should be installed into the carrier before installing the receiving frame into the

mounting bay of a computer or expansion chassis. A #2 Phillips screwdriver will be required

for installation.

1. Turn OFF power to the computer.

2. Open the computer system according to the manufacturers instructions. If

necessary, temporarily remove any expansion boards that may make installation

difficult.

3. To select the DE100i-SWC160 unit ID remotely through the computer system or

external expansion chassis, the appropriate cable from the system must be

connected to the ID Select Pins 1-8 on the rear of the receiving frame as shown

in Figure 8.

Pin 10

Pin 12

Pin 14

Pin 22

Pin 20

Pin 18

Pin 16

0439c

SYNC

RMST

DYST

FFAULT/Alarm Enable

Reserved

Factory-Installed Jumpers

(Do Not Remove!)

Fan 1 Enable

NOTE: Figure 8 applies to DE100i-SWC160 receiving frames Rev. B00 or higher only. Refer

to Appendix F for further information.