Data Silo DS100 User's Guide

DS100 (U320) User's Guide - Rev. A02 StorCase Technology, Inc.

Installation 13

Figure 13: Installing the DS100 2-Bay Drive Mounting Bracket

11. Connect the 4-pin DC power cable(s) from the DS100 to the drive(s).

12. Connect the ID select cable to the ID select interface connector on the rear panel of

the DS100 (Figures 7 & 8).

NOTE: Use the provided tie wraps included in the installation kit to prevent the power and

ID select cables from possible contact.

13. If necessary, reinstall the DS100 cover to check for proper drive bezel/cover alignment

and make any necessary adjustments.

14. Tighten the screws that fasten the drive mounting bracket to the chassis.

15. Reinstall the DS100 cover and fasten all screws.

16. Connect the power cable to the DS100 and turn ON the power switch. Should there

be any unusual sound, turn OFF the DS100 immediately, disconnect the power cable,

and remove the cover to locate the source of the problem. Verify that the power and

ID select cables are securely fastened with the provided tie wraps and are not contact-

ing the fan. Replace the cover.

0541A

ID Select

Cable

Power

Connector

I/O Cable

5.25" Drive

Mounting

Bracket

Drive

(Not Included)

Terminator

SCS

I ID

FAC