Operation Manual

storageoptions.com/support 17
4.5 User and device settings
4.5.1 Multi-device settings
If you have several HomeGuard IP cameras, it is possible to view them simultaneously (up to 9 cameras). Click
Refresh to ensure your cameras have been detected, the double click on the camera you wish to add. Enter the
Device Info as required then click Add. Once all the cameras are added, click Setup to confirm.
4.5.2 User Settings
The camera is setup with 3 user levels as default. You can change the name and password for each level.
Administrator can amend any of the camera’s parameters, Operator can view the live stream and amend minor
parameters, Visitors can only view the live stream and move the camera lens.
4.5.3 PTZ settings
Use this screen to amend Pan and Tilt settings.
NOTE
If you set Cruise Turns as Always, the cruise will stop after one hour.
4.5.4 Maintain
You can Restore the camera’s default settings, Reboot the camera, or Upgrade the firmware and Web UI loaded onto
the camera. Please check storageoptions.com/support for updated firmware.