Operation Manual

Page 39
8.11 – PAN TILT ZOOM (PTZ)
Use the PTZ Setup menu to configure settings for a connected PTZ camera (not included).
NOTE
Consult the instruction manual of your PTZ camera for information about your camera, including protocol
and baud rate.
To configure a PTZ camera:
1. Connect a PTZ camera to the BNC and 485A (TX, +) and 485B (RX, -) ports and power outlet.
2. Under PROTOCOL, select PELCO-D or PELCO-P for the selected channel.
3. Under BAUD RATE, select 1200, 2400, 4800, or 9600.
4. Under VERIFY, select ODD, EVEN, MARK, SPACE, or NONE.
5. Under ADDRESS, enter an address from 001-255 using the virtual keyboard. Refer to your PTZ camera`s
instruction manual for further details.
6. Click APPLY to save changes, then click CLOSE in the confirmation window.
7. Click EXIT to close the menu.