Operation Manual

Page 35
8.4 – SYSTEM INFO
This page shows system information, including the firmware version, MAC address, and system serial number.
There are no user-configurable settings on this page.
8.5 – MOTION DETECTION
Each channel can be configured to record based on motion being detected in the frame.
To configure motion detection:
1. Under STATUS, select ON to enable motion detection for that channel.
2. Under SENSITIVITY, select 1 (low), 2 (medium), 3 (high), or 4 (very high).
3. Under MD AREA, click SETUP. The red motion grid appears over the selected channel in full screen. Click the
blocks in the grid to enable or disable motion detection.
RED = motion detection enabled
CLEAR = motion detection disabled.
4. Right-click anywhere on the screen to return to the Motion
Detection menu.
5. Click APPLY to save changes, then click CLOSE in the confirmation
window.
6. Click EXIT to close the menu.