Instructions / Assembly

Pallet Rack User Instructions Preliminary Considerations

Step 9

You can continue adding units by standing upright frames and beams to complete each unit until a row is completed.

Step 10

When anchoring to oor, we recommend 1/2” bolt size anchors attached at foot plate of posts.

Step 5

Repeating steps 1-4, nish assembling all uprights necessary for pallet rack installation.

Step 4

With all horizontal and angle supports in place, tighten all nuts and bolts for nal assembly.

Step 6

To start a row, stand two uprights in proper pre-designated position with bottom of the lowest diagonal bar facing aisles (g. 7). Then

place beam between upright frames to position them (g. 8).

Step 7

At desired height, lower the beam into the tear drops of each upright. Beam must enter the slots

simultaneously until each safety clip is fully engaged into position (g. 9). Use a rubber mallet if

needed to get beam into a locked position.

Step 8

Repeat step 7 for remaining beams to be installed onto the starter unit. Ensure starting unit is square before attaching any additional units.

Pallet Rack Assembly

7. 8.