Instructions / Assembly

Pallet Rack User Instructions

Upright Assembly

Before Pallet Rack can be installed, Rack uprights must be assembled.

Step 1

Lay 2 upright columns parallel to each other with tear drops facing outward and in similar directions

(g. 1). Ideally columns should be elevated off the ground for easy assembly.

Step 2

Starting from one end and working your way up, install each horizontal support adjoining the two parallel upright columns (g. 2).

Horizontal supports are to be installed into the center holes of each 3 hole pairing along the length of the columns (g. 3). Use a set of

M8 bolt and serrated lock-nut (g. 4) to secure each end of a bar to a column. At this time do not fully tighten the bolts and nuts so

that some exibility may be maintained to help with the installation of remaining supports.

Step 3

Between each horizontal support a diagonal support must be installed. Starting from the bottom of the upright, use the rst hole

located above the rst horizontal support for diagonal support placement (g.5a). Place the opposite end of the diagonal support on the

rst hole located below the next horizontal support (g.5b). Secure the support to the upright with a set of bolt and nut for each hole

on each end. At this time do not fully tighten the bolts and nuts so that some exibility may be maintained for the installation of the

rest of the diagonal supports. Begin to insert diagonal supports in between the remaining horizontal supports in opposing positions to

complete the unit (g. 6).

2. 3. 4.

5a.

5b.