SDS
Safety Data Sheet
Acc. To OSHA HCS (29 CFR 1910.1200)
10/13/2015 Page 2 of 6
Trade Name: Stop Bugging Me! ™ Bed Bug RTU Spray
NFPA ratings (scale 0-4) HMIS ratings (scale 0-4)
Other Hazards
Results of PBT and vPvB assessment:
PBT: Not Applicable
vPvB: Not Applicable
3. Composition/Information on Ingredients:
Chemical characterizations: Proprietary
Description: Mixture of substances
Dangerous components: This product contains no materials classified as hazardous
4. First aid Measures:
Description of first-aid measures
General information: Immediately remove any clothing soiled by the product. Symptoms of poisoning, may
even occur after several hours; therefore, medical observation for at least 48 hours after exposure may be
necessary.
After inhalation: Supply fresh air; consult a doctor in case of complaints.
After skin contact: Immediately rinse with water. If irritation continues, consult a doctor.
After eye contact: Rinse opened eye(s) for several minutes with running water. If irritation continues consult
a doctor.
After swallowing: Rinse out mouth and then drink plenty of water. Vomiting may occur; immediately call for
medical help.
Information for doctor:
Most important symptoms and effects, both acute and delayed: Can cause moderate eye irritation and
dermatitis with prolonged skin contact
Danger issues: Moderate eye and skin irritation can occur
Indication of an immediate medical attention and special treatment needed: No additional information
available
5. Fire-fighting measures
Extinguishing Media
Suitable extinguishing agents: CO2, extinguishing powder or water spray. Fight larger fires with water spray
or alcohol resistant foam.
For safety reasons unsuitable extinguishing agents: None.
Special hazards arising from the substance or mixture: None known
Advice for firefighters
Protective equipment: Wear self-contained respiratory protective device. Wear fully protective suit.
Additional information: No further relevant information available
6. Accidental release measures
Personal precautions, protective equipment and emergency procedures: Wear protective equipment. Keep
unprotected persons away. Ensure adequate ventilation.
Environmental precautions: Do not allow product to enter sewers, surface of ground water.
Methods and materials for containment and clean up: Absorb with liquid-binding material (sand, diatomite,
acid binders, universal binders sawdust). Send for recovery or disposal in suitable receptacles. Dispose
contaminated material as waste according to Sec. 13