User's Manual

60
ĻCollimate target A0 with
horizontal clamp and tangent
part.
Collimate A0
Ļ Click “Continue”
key.Then slope
distance,horizontal
distance and elevation
difference from
instrument to A0 and
coordinate of A0 will be
shown.
1)Ć ˈ 2)Ć
ǏContinueǐ
1)Ć Click “Setup” key to set instrument height and prism height.
Ć2)Click “Exit” to finish Angle Offset Measurement
ƔSet instrument height/prism height before Offset Measurement.
ƔRefer to “4.5.1” to set coordinate of occupied point.
2) Distance Offset Measurement
The measurement of a target point apart from a prism is possible by inputting offset
horizontal distance of front and back/left and right.