User's Manual

91
unnecessary errors in the results.
Operation
Interface
①In {Setting}press [4]〈4.EDM〉to enter
{EDM Setting}. Press [★] in the
measurement related interfaces then
select 〈2.EDM Set〉 also can enter
{EDM Setting}.
②Use [▲] [▼] to highlight a item then
use [ ] [ ] to toggle the options
available.
③ Press [F3] 【 OK 】 to confirm the
settings.
〈Refl.Type〉: Set the type of target on distance measuring.
Prism : The target is reflector prism.
Tape : The target is reflector tape.
NonPrism : The target is object itself, i.e., reflectless.
〈EDM Mode〉: Set the mode of EDM working.
Standard : Fine mode, default high precision mode.
Fast : Fast mode with increased measurement speed but possibly slightly
reduced accuracy.
Track : Continuous measuring mode.
Repeat : Repeat measuring until manually stop.
Average : After measuring defined times on standard mode, average the
results.
〈Constant〉: Input the prism constant when〈Refl.Type〉is Prism.
The unit is mm and input range from -999.9 to 999.9.
〈Pointer〉: To emit a laser beam coaxial to the telescope, creat a visible
red spot on the near target to indicate the current aiming point position
OFF/ON