Product Manual

3
Rev040617
MOUNTING AND WIRING THE LIGHT
NOTE: DO NOT MOUNT ON THE GROUND, RECOMMENDED INSTALLATION HEIGHT IS BETWEEN 8 AND 12 FEET
1. Turn off power from the circuit breaker box. DO NOT rely on only the switch power being turned off.
2. Unscrew the two (2) Fixture cover plate Screws (D) and remove the Fixture cover plate (C).
3. The fixture cover plate contains two (2) punch metal punch outs. If you are completing a wall installation remove the
back punch out. If you are going to mount to a pole using conduit remove the bottom punch out
4. Install the light fixture (A) to the wall and secure with the three (3) mounting screws (E). Once complete, install the
top screw and tighten. If installing to a wall or building, pre-drill holes and use appropriate anchors.
5. Connect supply wires with wire nuts as shown in the figure above.
Black supply wire connects to the Black power supply wire (Live)
White product wire connects to the White supply wire (Neutral)
Green product wire connects to the Ground wire
For proper connection, place wire nut over wires and twist clockwise until tight.
6. Install the fixture cover plate (C) and secure with the two (2) fixture cover plate screws (D).
7. Turn on your electricity after install has been completed.