Installation Sheet

Oval Stainless Sink Undermount Installation

Please read these instructions carefully before you begin. Also, review the

recommended tools section and lay out all components to assure you have

the correct tools, items and quantities needed for proper installation.

Caution! Stone sinks and countertops are very heavy. Please use care and caution when handling.

Important: Do not use an oil-based sealer, silicone, or plumbers putty with stone. These products will stain if

applied near the surface. Use a latex-based caulk recommended for use with tile and stone.

All installation procedures must comply with all applicable local plumbing and building codes.

Required tools:

Screwdriver Cloth

Adhesive Caulk/Sealant such as

DAP Qwikseal

or Henkels Polyseam Seal

Supplied parts:

Oval Stainless Sink Undermount clips (x4) Washer (x4)

PAGE 1
Oval Stainless Sink Undermount Installation Please read these instructions carefully before you begin. Also, review the recommended tools section and lay out all components to assure you have the correct tools, items and quantities needed for proper installation. Caution! Stone sinks and countertops are very heavy. Please use care and caution when handling. Important: Do not use an oil-based sealer, silicone, or plumbers putty with stone. These products will stain if applied near the surface.
PAGE 2
Instructions: 1. 2. 3. 4. 5. Verify cabinet and stand clearance. Clean the underside of the countertop and the rim of the sink. Loosely install the clips using appropriate screws and anchors provided by your countertop fabricator. Apply DAP Qwikseal® or Henkels Polyseam Seal® on the rim of the sink. Position the sink under the opening. Hold the sink in place and rotate each clip over the rim. Evenly tighten the clips to secure. 6. Immediately wipe away any excess sealant. 7.