Installation & Assembly

8/20/2016
Cleaning
Excess dirt and film may be removed using clean water and a stiff brush. It is important not to
allow thin set to dry on face of the stone. Remove it prior to it hardening.
WARNING: Do not use acid wash because it has been known to have an adverse effect on stone
and can possibly cause staining, etching, and rusting.
Sealing the stone
Stone Design Manufactured Stone Veneer may be sealed with a penetrating, water based
sealer only after thoroughly curing which usually takes 4 weeks on inside work. Follow the
manufacturer's instructions on the application of any sealer. Sealed stone may be easier to
keep clean and maintain than unsealed stone and certain sealers also repel stains. Always test a
sealer on a sample of stone or an off-cut before applying to the entire application to ensure any
color enhancing and sheen properties of the sealer match the desired result.
Sealing Stone Design Manufactured Stone Veneer is recommended for certain applications,
such as moisture rich environments, and some exterior applications, depending on the level of
exposure and other factors, including climate and other environmental factors.
Disclaimer: The information provided here is intended to be general only. It does not purport to
be comprehensive. You should not act on the basis of information contained on this site
without obtaining qualified professional advice from a licensed professional which can be
tailored to suit your specific circumstances and needs.
Professional Installation Recommended. Stone Design Manufactured Stone Veneer can be
installed by most home handymen with a limited knowledge of building and construction. We
strongly recommend that Stone Design Manufactured Stone Veneer is to be installed by
professional licensed tradesmen or contractors.